Guide to Hang Anything on Your Wall Easier Than Ever

Guide to Hang Anything on Your Wall Easier Than Ever
Like Tweet Pin it Share Share Email

Wall hangings are a wonderful form of artwork. They are normally hung on the walls of a building with a view of making the wall look cute and awesome. Such artworks are used in decorating the walls of the living room, bedrooms, and even in kitchen walls. The easiest method is, of course, to use the best stud finder for finding the studs and this device is used to find the studs that are located behind the finished wall.

If we are planning on hanging heavy artwork or if we want to install a new chandelier from the ceiling, we need to make sure that these things are hung on a stud so that they are going to be secure and not fall on the ground.

You can also use mollies or butterfly anchors, but these methods do not work very well and it may cause damage to the wall and also to the objects that we are going to hang. The best thing to do is to use a stud for hanging heavy objects.

Hang Your Favorite Artwork Easily on the Wall

Usually, the studs are placed behind the drywall. To find the studs, one needs to have the right tool. Otherwise, we could end up banging on the walls and making marks or even holes in spots while we are trying to locate the studs.

Using a stud finder is not a big task. There are different types of models of stud finder are available in the market. Some stud finders will flash a light when a stud is detected and some other type of studs will produce beep sound.

Hence, you should remember about these tools is that they are all different, and all these tools are not used in the same manner. Some models are more complicated when compared to others, but most of the tools are very simple to use and detect the studs.

Process of Detecting Studs

There are some important tips to find studs using these tools. To locate studs one has to remove any painting or photos hanging and should make sure that the wall is made clear. Then they should turn on the stud finder tool and should hold it against the wall and press the button until the light gets flashed or get a beep sound.

This will calibrate the tool. This will indicate which parts of the wall are real walls and which parts have a higher density and are studs. If we want to hang something heavy, we have to place the device flat against the wall.

To get the best result, we have to move it slowly in a horizontal direction. When we hit a stud, the device will beep or flash at the outer edge and again at the other edge. With a pencil or using, marker one can mark the places, so that we can know where the studs are placed. Once the scanning process is over, we can hang our artwork, photos are any hangings that we wish to hang on the wall.